AQUADRAIN ICD (Internal Cavity Drain)

 

 

The CETCO range of cavity drain membranes are high quality waterproof basement tanking materials giving a wide choice of stud height (drainage capacity) and plaster finish (dry lining or wet plaster). For use on walls, floors, vaults and tunnels with minimal surface preparation required. Also suitable for external foundation waterproofing and to provide insulated dry lining for walls above ground level which may not be suitable for conventional plaster finishes.

AQUADRAIN ICD membranes are suitable for use in type ‘C’ (drained protection) structural concrete constructions in accordance with BS 8102:1990, Clause 3.2.4.

 

GAS BARRIER PROTECTION

AQUADRAIN ICD membranes provide a gas barrier system by the creation of an air gap when the studs of the membrane form a cavity within the building which allows the gas to flow freely beneath them to an extraction point. When dealing with gas situations it is imperative for all joints to be sealed with care. It is recommended that CETCO DS30 be used for primary sealing, with CETCO SS80 SEAMTAPE as a secondary layer of sealing protection.

 

 

AQUADRAIN ICD 8mm

 

CAVITY DRAIN MEMBRANE

 

 

AQUADRAIN ICD 8mm is a medium capacity drainage membrane (4 litres/m²) for floors and walls both above and below ground level. When used on basement floors it is recommended that perimeter drainage channels are provided to optimise the flow of ground water towards the sump location.

 

 

Technical Data

 

 

AQUADRAIN ICD 20mm

 

HIGH CAPACITY CAVITY DRAIN MEMBRANE

 

 

AQUADRAIN ICD 20mm is the highest drainage capacity membrane in the AQUADRAIN ICD range giving a void volume of 14 litres/m². Suitable for use on floors and walls in very wet situations or where the large stud height is desired to maximize insulation values. When used on floors AQUADRAIN ICD 20mm can normally be installed without the need for perimeter drainage channels and, when overlaid with concrete, the large diameter studs will give high point load resistance capabilities (150 kN/m²) to support load bearing walls built off the slab

 

 

Technical Data

 

 

AQUADRAIN ICD ANCILLARY PRODUCTS

 

 

Technical Data